Böhm Elektronik > Loading devices

Loading Device FES-S

1 or 2-row filling of loading plates possible.
Spring dimensions from approx. Da 2.0 mm to Da 28 mm are possible.
Outputs of up to 6,000 pieces/hour are possible depending on spring design.

The springs are fed into the vertical tubes located over the holes of the separating unit with a feed hose. During the pulling movement of the loading station, the springs are separated and filled into the holes of the loading plate. After each filling the loading device is pulled back by a return cylinder and the loading process is repeated. Controller with interface to grinding machine. The automatic feeding of the springs to the loading device can be carried out with various devices depending on the spring geometry.

Round feed pots with mechanical baffle plates for springs that cannot be untangled, e.g. WF 200; WF300; WF450;
Round feed pots with electronic sorting probe; quick conversion to other spring dimensions is possible e.g. WF 200; WF300; WF450;
Automatic spring feed system, with sorting probe and additional untangling
FEW1 up to spring diameter of 7 mm; FEW2 up to spring diameter of 12 mm;
Drum feeder for springs that need not be untangled (small space requirement) TF 300, TF 450

Beladeeinrichtung FES-T

Loading device for cycled loading plates FES-T

The springs are filled into two bunkers as bulk goods. The correct dose for filling up the round feed pots is achieved with the bunkers. In the feed pots the springs are sortedwith a vibration drive and adjustable baffle plates, and transported to the loading device with a longitudinal conveyor (buffer section). At the end of the buffer section the springs are filled into the loading plates in 2 rows with gripper jaws and press-in cylinders.

* Pot WF 300: Spring dimensions from approx. Da 6,0 mm to Da 15 mm are possible.
* Pot WF 450: Spring dimensions from approx. Da 12 mm to Da 28 mm are possible.
* Outputs up to 5.000 pieces/hour are possible depending on spring design.
* Springs must be inserted in loading plates.
* Feeding and loading device at same working height, resulting in simple system operation.
* Control for entire process and interface to grinding machine.

Additional device Electronic sorting probe for springs that are entagled.
This enables quick conversion to other spring dimensions, and permits sorting of springs that cannot be easily fed in without mechanical problems.